Please check out my blog for more details.

Prerequisites: - Traktor 2.11 (though this should be backwards compatible, read below about drivers) - Denons latest 3264 bit driver ( ) - I was doing this with windows 10 64bit.

Denon Mc3000 Download My Custom

Go to Traktor Bible to download my custom mapping file preferrably.

Its basically a rework of the official Denon map file you can find on their download page, with a couple extra nice features.

What matters is that I got it to work with Traktor 2.11 with the configuration listed herein.

Procedure: - Remove your current ASIO driver, unless youre already using the one above.

Install the latest ASIO driver you just downloaded - Ensure that your Denon controllers mixing mode is set to PC mix (on the back of the deck near the power supply) - Run the Setup Wizard, using the following guidelines: 2 track decks 2 sample decks (important), Internal mixing mode (so say no to external mixer) - Once you have run the setup wizard thingy, load the latest TSI map file, OR load the TSI map file I provided on Traktor Bible.

Make sure that it is selected correctly, whatever name it has when you load it (it may be different than what you see on the screenshot below).

Next, go into the preferences and ensure that your settings match the ones in the pictures below.

You will notice from the first image that I have the 4 deck configuration.

The real important ones are the ASIO driver selection, the proper TSI loaded, the 4 deck configuration, and the Output routings.

NOTES: - If you want to attempt to use the 2.2.2.

ASIO driver, follow the procedure as above with that driver.

More details on my blog.

The custom TSI mapping I provided will enable you to toggle the main mix recording function with the record button on your controller, a very handy control.

Denon Mc3000 Free To Reconfigure

Once you have this config stable, save it and feel free to reconfigure your set up according to your taste from there.

Note that Denon has recommended in the past to use the internal mix mode on the controller if you use two decks only.

Do NOT confuse this with the mixing mode inside the Traktor prefs.

You will want to test out which one (i.e.

Internal vs External mixing in the Traktor prefs) works best if you switch mixing modes on the controller.

I had the best results so far with the configuration described in this post.

Denon Mc3000 Driver For Mac